Sam Little
16 de julio de 2026
Mak sure rubber cap is removed on guy's supply connection
Make sure you remove small rubber cap from the pressure gun where you connect the supply line to the connector fitting on the gun. Both are black. Initially I did not see the small rubber cap and the pressure washer would not shoot water. About to send it back when I saw it and removed it. Then worked great. It has the right amount power when using the 40 degree nozzle to clean a minisplit ac inside evaporator unit and the outside condenser without damaging the delicate aluminum fins. Therefore this is lower than most pressure washers, but what I needed especially cleaning the blower fan on my Della minisplit ac units. I must say that I have only cleaned one of my four minisplits so far, so I assuming if will hold up. If it fails I will give an update..Ver másVer menos
2 personas la encontraron útil



















