John V
Great mount when you know where you want your monitors
I bought this a few months back and finally got around to installing it. It's a very sturdy unit depending on what it's mounted too and the weight of your monitors. For me, it's mounted to the edge of a 1 1/4" solid cherry desk top, so that wasn't a concern for me. If I were mounting it to a thinner desk, I would have went with some plates to spread the load on top and bottom. I did read a lot of concerns about the mount leaning when heavier monitors are installed and I would agree with that being a potential issue, but it really depends on what you're mounting. With a single, fairly light 32" LG gaming monitor up top, the lean wasn't enough to be a concern. With a 3rd monitor added (more info further down), it did lean both forward and off to one side quite a bit, but there's a solution for that IF you're willing to put a few holes in the wall behind it (for some, this defeats the purpose, but for me it was about having no physical stands on my desk).The photo attached is of a 49" Samsung Odyssey G9 OLED, a 32" LG QHD gaming monitor, and a 32" Dell QHD Gaming monitor mounted in portrait. The mount itself is sturdy, the arms are fairly sturdy as well and secure to the pole assembly easily enough, though take note that once the height is set, that's your height. You can adjust the monitors position in all other directions except vertical (and tilt requires loosening a bolt to make that adjustment). In the few days this has been up, they haven't moved at all. I have silver marker on mine just out of curiosity and there has been no visible movement at all.On to the 3rd arm AND the leaning pole stuff. I installed 2 items in addition to this mount. The top and bottom monitors are on the included arms. The additional arm is the Wali 3 tier pole mount, ASIN B07QXJ5GJV. It is a longer arm with an extra tier added. It's tiered though, so it does raise (or lower) the monitor an inch and a half over the mounting location. This arm is just as sturdy and worked perfectly on this pole mount. The additional mounting bracket I used is the WYSIWYKA 2PCS 304 Stainless Steel Pipe Supports for OD Pipe 38-40mm, Adjustable Height 100-200mm. This is ASIN B09MVQRVKD and stands off the wall by 100-200mm. I have it down at 100mm and it was a bit long for my desk being ~3.5" from the wall. I pulled my desk out just a bit to compensate for that, but they do have a 50-100mm version (B09MVQQBV6). If you're going to be almost directly against the wall, a standard rubber cushioned clamp like in ASIN B07GRP94BD should do the trick (but I doubt you want a 12 pack).All told, I'm very happy with this mount. It isn't as simple of an install as a standard gas arm mount, but it's rigid and it does hold the 80lb or so in monitors without a sweat. To give an idea, with that previously mentioned pipe clamp up top, I applied about 135lb to it before mounting any monitors (in the form is UPS batteries in sturdy bags, spread across all 3 arms) and it held on without issue. A great buy so long as you know where you want the monitors to liveVer másVer menos
1 persona la encontró útil
